Professional Sink & Faucet Installation in Minneapolis, MN

Ready for a kitchen or bathroom upgrade? Dealing with a faucet that drips, leaks, or just gave out? We handle every type of sink and faucet installation for Minneapolis homeowners, with flat-rate pricing and no hourly charges.

Schedule your service call today

We'll get back to you fast, usually same day.

"*" indicates required fields

Company

This field is for validation purposes and should be left unchanged.

Name*

First Name Last Name

Email*

Phone*

Service Type*

Message

Signs It's Time to Replace Your Sink or Faucet

Minneapolis tap water is notoriously hard, and mineral buildup quietly destroys faucet cartridges and supply line connections over time. If your faucet drips constantly, loses pressure, or has handles that feel stiff or corroded, hard water is likely the culprit.

Older Twin Cities homes add a second layer: shut-off valves under the sink can be so corroded they won’t fully close, turning what looks like a simple faucet swap into a more involved repair. Catching it early keeps the job manageable and the cost predictable.

Faucet drips even when turned fully off
Noticeably lower water pressure at the tap
Rust stains or mineral crust at faucet base
Cracked, chipped, or permanently stained basin
Water pools slowly or backs up in the basin

What Our Sink & Faucet Installation Service Includes

Whether you’re swapping out a worn kitchen faucet, upgrading to an undermount or farmhouse sink, or replacing a bathroom vanity fixture from scratch, our team handles the complete installation from shutoff to silicone seal. We work with every sink type: drop-in, undermount, farmhouse, vessel, wall-mount, bar, and utility sinks, paired with any faucet style.

What We Handle on Every Installation

Shut off at angle stops or main if corroded
Remove old faucet with basin wrench from below
Set new sink with silicone or plumber's putty
Feed faucet through deck holes, torque from below
Run fresh braided stainless supply lines
Address hole-count mismatches with deck plate

Disconnect supply lines, P-trap, drain assembly
Cut caulk seal and lift out existing sink cleanly
Secure with mounting clips or undermount brackets
Install drain assembly, connect new PVC P-trap
Handle garbage disposal flange when included
Inspect and replace corroded angle stop valves

Every installation finishes with a pressurized leak check at every joint, inspected under a flashlight before a fresh bead of 100% silicone is run around the sink perimeter. Faucet-only swap: 45 min to 1.5 hrs. Full replacement in Minneapolis: 2 to 4 hours.

Our Sink & Faucet Installation Work in Minneapolis

What Minneapolis Homeowners Say About Our Sink & Faucet Work

    
 
 
       Posted on Google  
   
   Matthew Wick 
 
 
 
 Trustindex verifies that the original source of the review is Google. Super friendly and timely and also do a great job! thank you!
  
 
      Posted on Google  
   
   Auden Meal 
 
 
 
 Trustindex verifies that the original source of the review is Google. Jason and his team are fantastic. I could not recommend these guys enough. They are honest, reliable and experienced. If you are looking for any type of plumbing help, these are your guys. They helped me out big time with a shower project and the result is incredible.
  
 
      Posted on Google  
   
   Tom Harlan 
 
 
 
 Trustindex verifies that the original source of the review is Google. They did a great job spot on with quotes and I will use them again
  
 
      Posted on Google  
   
   Tracy Ringger 
 
 
 
 Trustindex verifies that the original source of the review is Google. As always Tony was on time and very professional. He fixed what needed to be fixed and gave me an estimate on a future job. I always feel confident in his work.
  
 
      Posted on Google  
   
   elizabeth kawecki 
 
 
 
 Trustindex verifies that the original source of the review is Google. Hands down. These guys are the best!!!!
  
 
      Posted on Google  
   
   Ken Swanson 
 
 
 
 Trustindex verifies that the original source of the review is Google. Great response time and very professional job. Made everything look good as new!
  
 
      Posted on Google  
   
   Devon Bratz 
 
 
 
 Trustindex verifies that the original source of the review is Google. Fixed an issue with a previous job for free, very friendly techs.

Why Minneapolis Homeowners Choose Twin Cities Premier Plumbing

Your Price, Set Before We Start

One flat rate quoted upfront before a wrench is picked up. No hourly billing, no parts markup. Invoice matches quote, every time.

We Handle What's Under the Cabinet

Corroded shut-offs and wrong hole counts are common in older Minneapolis homes. We find them upfront and give you options, not a runaround.

Licensed Plumbers, Not Handymen

Every job done by a licensed, insured plumber with 10+ years of experience. Your sink, countertop, and cabinet are protected throughout.

Financing via WiseTack

Upgrading multiple fixtures or tackling a bigger project? Low monthly payment financing through WiseTack so you don't have to put it off.

What to Expect During Your Sink & Faucet Installation

Assess & Shut Down

Inspect existing setup, confirm hole count and angle stop functionality, then shut off water supply before touching any hardware.

Remove Old Hardware

Disconnect supply lines and P-trap, use basin wrench from below to release mounting nut, lift out old faucet and sink cleanly.

Install New Sink & Faucet

Set sink with silicone or plumber's putty, torque faucet hardware from below, install drain assembly and connect new PVC P-trap.

Reconnect & Pressure Test

Run fresh braided stainless supply lines, pressurize slowly, inspect every joint and connection under a flashlight before proceeding.

Final Seal & Walkthrough

Apply 100% silicone perimeter bead, clean cabinet interior, walk you through operation, confirm satisfaction before packing up.

Claim Your Same Day Service Or Call (763) 343-9806

How Much Does Sink & Faucet Installation Cost in Minneapolis?

The cost depends on sink type, faucet style, and what’s discovered under the cabinet once old hardware comes out. In older Minneapolis homes, corroded shut-off valves and mismatched hole configurations are common discoveries that affect the scope of the job.

Rather than post a range that may not reflect your situation, we provide an upfront quote before any work begins. Your price is set before the first fitting is touched. No hourly billing, no parts markup, no surprise invoices.

Financing available through WiseTack for larger projects, with low monthly payment options.

You May Also Need

Sink Repair

Something leaking, draining slowly, or not sealing right? We diagnose and fix sink problems without automatically pushing for a full replacement.

Learn more

Emergency Plumbing

Burst supply line, major leak, or shut-off valve failure? We take emergency calls for situations that cannot wait until the next business day.

Learn more

General Plumbing Service Work

Tackling a bigger project or multiple fixtures at once? We handle all residential plumbing service work, from supply lines to drainage.

Learn more

Sink & Faucet Installation Across the Minneapolis Area

We provide sink and faucet installation in Minneapolis, St. Louis Park, Plymouth, Maple Grove, New Hope, Golden Valley, and surrounding communities throughout the Twin Cities metro.

Sink & Faucet Installation FAQ

How long does sink and faucet installation take?

A faucet-only swap typically runs 45 minutes to 1.5 hours. A full sink and faucet replacement takes 2 to 4 hours depending on sink type and what’s found under the cabinet. Older Minneapolis homes often have corroded shut-off valves that add time to the job. We identify this during assessment and let you know the full scope before work begins.

How much does sink and faucet installation cost in Minneapolis?

Cost depends on sink type, faucet style, and what comes up under the cabinet. We provide an upfront quote before any work starts, so you know the full price in advance. No hourly billing, no parts markup, no invoice surprises. Financing available through WiseTack for larger projects.

How do I know if I need a full replacement or just a new faucet?

If only the faucet drips or loses pressure, a faucet-only swap is usually right. If the basin is cracked or you want to change sink styles, a full replacement makes more sense. During assessment we walk you through both options and the cost difference so you can decide.

Do you offer same-day sink and faucet installation in Minneapolis?

In many cases, yes. Same-day availability depends on our schedule that day. Book online or call (763) 343-9806 to check. We also handle emergency plumbing calls when water cannot be shut off or a supply line has failed.

Should I buy the sink and faucet myself, or can you supply them?

Either works. Many Minneapolis homeowners prefer to choose their own fixtures, and we’re happy to install customer-supplied products. If you want recommendations, we can point you toward reliable brands like Delta, Moen, and Kohler and help you avoid hole-count mismatches before you buy.

Can you install farmhouse, vessel, and undermount sinks?

Yes. We install drop-in, undermount, vessel, farmhouse (apron-front), bar, utility, wall-mount, and pedestal sinks with any faucet configuration. Undermount and farmhouse styles require extra care with mounting clips and countertop support, which we handle as part of the installation.

What warranty do you provide on your installation work?

All labor carries a workmanship guarantee. If something we installed leaks or fails as a result of our work, we come back and make it right. Manufacturer warranties on faucet and sink hardware apply separately. Ask about specific terms when you receive your quote.

Still have questions? Call (763) 343-9806 or contact us online

Let's Get Your New Sink or Faucet Installed the Right Way

Schedule your free estimate online or call us for same-day service.

Claim Your Same Day Service Or Call (763) 343-9806